Home > Install Guide >Snap In Bumper Kits
Installation Guide for Snap-In Bumper Kits
See Also: |
||
GENERAL HINTS: Popping out old, hard and cracked rubber bumpers takes little more than a screwdriver and some careful prying. To prevent scratching the surface, you may want to use a non-metal object to cushion the screwdriver as you pry. |
If a plastic anchor breaks off and remains in the hole, try poking it through or even carefully using a tiny drill bit to remove it. DOOR BUMPERS: Align anchors with door holes and push in (Figure 6A). You may use a light lubricant, such as soap, and the handle end of a small screwdriver to push the carrot in solidly |
HOOD BUMPERS: GLOVE BOX & CONSOLES: These tiny bumpers help prevent glove box or console noise and help keep your car from the damage associated with opening and closing these small doors. Use pliers to pull the old ones out and push in the new ones. Pulling a tail from the back is also helpful (Figure 6B). |